2006 Arctic Cat ATVs factory service and repair manual, Page 308Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 308

A CAUTION part was replaced, proper engine break-in procedures must be followed (see Section 1)If the proper engine break-in
EngineITransmission 3-318 26Pour 2.9 (3 U.Sqt) of premixed Arctic Cat Antifreeze (pln 0638-395) into the cooling systemAllow
coolant to settle and then fill to the bottom of the stand pipe in the radiator neck Removing Engine Transmission Many service
procedures can be performed without removing the engineltransmission from the frameClosely observe the note introducing each
sub-section for this important information1 NOTE: For ease of removal of components, it is advisable to remove front and
rear racks, fenders, and side panels prior to engine removal27Install the seat making sure it "locks" into position B AT
THIS POINT pick-up coil, starter torque limiter, primary cam chain, water pump impellerlseal, starter clutch, and starter
clutch gear, the enginetransmission does not have to be removed from the frame Page: 308 Arctic Cat ATV 2006 -All Models