2006 Arctic Cat ATVs factory service and repair manual, Page 309Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 309

Secure the ATV on support stand to elevate the wheels 1Make sure the ATV is solidly supported on the sup- 1 port stand to
then remove the storage compartment box8Remove the instrument pod; then remove the front rack and front body panel (see Section
8)9Remove the front V-belt cooling snorkel; then remove the rear V-belt cooling boot 4Remove the four screws securing the
electronics mounting tray; then remove the entire assembly 10Disconnect the alternator lead connector (A); then disconnect
the pick-up coil lead (B) and the speed sensor connector (E) 5Drain the coolant from the cooling system; then drain the oil
from the enginetransmission 11Remove the neutral position connector (F) and reverse position connector (H); then disconnect