2006 Arctic Cat ATVs factory service and repair manual, Page 316Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 316

Top-Side Components 1 NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to
Be sure the crankshaft is on TDC of the compression stroke of the front cylinder or valve damage could occur 2Remove front
and rear camshaft chain tensioners by first removing the spring cap (D)Account for one washer (C), one spring (B), and one
guide rod (A) for each tensioner 1 NOTE: If the left-side components have not been removed, remove the spark plugs and timing
inspection plug (A); then using the recoil starter, rotate the crankshaft to top-dead-center (TDC) of the compression stroke
of the front cylinderTF is top-dead-center front This is ratchet-type chain tensioner and must be completely removed and
reset if the mounting bolts are loosenedRetightening the mounting bolts after loosening will cause damage to the tensioner