2006 Arctic Cat ATVs factory service and repair manual, Page 320Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 320

Center Crankcase Components 1 NOTE: This procedure cannot be done with the engineltransmission in the frameComplete Removing
bolts (Amm) (Bmm) 1 NOTE: The right and left crankcase halves are machined as an assembled set; therefore, they must be replaced
as set Disassembling Crankcase Half 1Using press, remove the crankshaft from the right case; then mark matching marks on
the connecting rods and end caps B AT THIS POINT Connecting rod side clearance (A) should be measured with feeler gauge (B)
before disassembling as connecting rods have to be installed for this measurementMaximum serviceable side clearance is 0.7
mm (0.028 inConnecting rods or crankshaft will have to be replaced if measurement exceeds specification Remove the shift