2006 Arctic Cat ATVs factory service and repair manual, Page 321Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 321

Connecting rods are machined with the big end caps installedSevere engine damage will result if the caps are not installed
rods (A) and caps (B) 6Remove the circlip (A) 1NOTE: Connecting rod cap should be immediately installed on its connecting
rod to prevent mismatch 3Remove the three cap screws (A); then remove the shift shaft cover (B) 7Remove the spacer (A), idler
gear assembly (B), and washers and spacer (C); then remove low and high range gears (D) 4Remove the shift shaft spring anchor