2006 Arctic Cat ATVs factory service and repair manual, Page 331Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 331

3Place the cylinder on the surface plate covered with #400 grit wet-or-dry sandpaperUsing light pressure, move the cylinder
the bore is severely damaged or gouged, replace the cylinder Inspecting Cam Chain Guide 1Inspect cam chain guide for cuts,
tears, breaks, or chips2If the chain guide is damaged, it must be replacedHoning Cylinder 1Using slide gauge and dial indicator
or snap gauge, measure the cylinder bore diameter in three locations from tou to bottom and again from top to bottom at 90
from the first measurements for total of six measurements, The trueness (out-of-roundness) is the difference between the
highest and lowest readingMaximum trueness (out-of-roundness) must exceed specifications measurement exceeds the limit, Or
replace the cylinder to accommodate an oversized piston and rings NOTE: Oversized piston and rings are available in 0.50
mm (0.020 in only Measuring Camshaft Runout 1 NOTE: If the camshaft is out of tolerance, it must be replaced 1Place the camshaft