2006 Arctic Cat ATVs factory service and repair manual, Page 332Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 332

2Rotate the camshaft and note runout; maximum tolerance must not exceed specificationsMeasuring Camshaft Lobe Height 2Place
washers to 0.9 kg-m (6.5 ft-lb), cap screws 5-6 to 1.0 kg-m (7 ft-lb ), and cap screws (A) to 1.0 kg-m (7 ft-lb) 1Inspect
the bearing journal for scoring, seizure marks, or pitting2If excessive scoring, seizure marks, or pitting is found, the
cylinder head assembly must be replacedMeasuring Camshaft to Cylinder Head Clearance 1 NOTE: Do not rotate the camshaft when
measuring clearance 4Remove the cap screws securing the rocker case to the cylinder; then remove the rocker case and camshaft5Match