2006 Arctic Cat ATVs factory service and repair manual, Page 335Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 335

2Install the engine brake cover making sure the seal is not damaged; then install the engine brake actuator and secure with
(pln 0444-185) and Rods (pln 0443-406) onto the V-belt cover; then install and tighten the two cover bolts CIf the measurement
is less than 1.33 mm (0.052 in, install the yellow actuator lever assembly (pln 3201-427)If the measurement is more than
2.47 mm (0.097 in, install the green actuator lever assembly (pln 3201-428)If the measurement is not within the specified
length after the actuator lever assembly is replaced, install the V-belt cover assembly and install the uncolored actuator