2006 Arctic Cat ATVs factory service and repair manual, Page 336Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 336

DRIVEN PULLEY ASSEMBLY Disassembling 4Relax the spring by removing the nut and spring holder; then remove the spring seats
matching marks (A) and (B) on the movable sheave (C) and stationary sheave (D) to allow installation in the same position
2Place the driven pulley assembly onto the compressor tool base 3Tighten the nut against Spring Holder (pln 0444-162) (C)
to compress the springs; then using circlip pliers (B), remove the circlip (A)6Wipe out excessive grease; then using standard