2006 Arctic Cat ATVs factory service and repair manual, Page 341Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 341

2Maximum diameter must not exceed specifications1 NOTE: Always tighten connecting rod cap nuts to the specified torque value
must be within specificationsDo not move the connecting rod with the plastigauge installed 6Place the crankshaft on set of
blocks; then mount dial indicator and base on the surface plate7Slowly turn the crankshaft and note the readings at the uoints
indicatedCrankshaft runout must be lessthan specifications 4Measure the crank pin diameter (A) and check the crankshaft marking
(B)If no mark is on the crankshaft, the crank pin diameter should be within specificationsIf the crankshaft is marked with
"0,"crank pin diameter should be within specifications1NOTE: If the crank pin diameter does not coincide with the marking,