2006 Arctic Cat ATVs factory service and repair manual, Page 344Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 344

5Using special deep socket (B), remove the output shaft retainer nut (A) Assembling Crankcase Half 1 NOTE: Be sure to clean
hex wrench (D), remove the bearing retainerRemove the ball bearing from the housing Using press, install ball bearings (A)
and (B) into the crankcase making sure that the seal on bearing (B) is directed toward the crankcase; then press in needle
bearings (C) and (D) until flush with bore (insert bearing (D) from the outside)Install the oil pressure relief valve (E);
then coat all bearings with clean engine oil 3Install the rear cylinder camshaft chain guide (A) and tighten bolt (B) to