2006 Arctic Cat ATVs factory service and repair manual, Page 345Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 345

6Select connecting rod big end inserts using the following chart and the markings on the crankshaft and connecting rod1 Big
(B) and (C) until flush with bore (insert bearing (B) from the outside)Coat all bearings with clean engine oil 5Apply grease
to the lip (A) of the crankshaft oil seal (B); then press the seal in so that it sits mm (0.12 in inward (C) from the end
of the housing 7Install the inserts into the connecting rods and caps; then use plastigauge (A) to measure connecting rodlcrankshaft