2006 Arctic Cat ATVs factory service and repair manual, Page 346Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 346

1NOTE: Do not move the connecting rod with plastigauge installed or the reading will be compromised 8Remove the connecting
marks (B) on both connecting rods are directed towards the outside of the crankshaft and the grooves (C) of the cap and connecting
rod are on the same side13Install spacer, toothed washer (A), and the circlip on the driven shaft 10Install the crankshaft
assembly in the right crankcase half11Using press, install the driven shaft in the crankcase until it is bottomed; then install
the needle bearings (B) on the low gear (A) along with the high gear (D)14Apply clean engine oil to the shift rod (A), shift