2006 Arctic Cat ATVs factory service and repair manual, Page 348Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 348

2Apply blue Loctite #242 to the thread area (C), except tip (D) of left case cap screw (3); then install and tighten the
and driven shaft turn freelyIf any of the shafts don't turn freely, separate the crankcase halves to locate the problem6Using
the bearing driver (A), drive the bearing into the housing until it bottoms out 3Install the breather tube (A) on the crankcase
fitting aligning the white line on the tube with the mark (B) on the crankcase; then install the clamp (C) directing the
open end toward the left side (D) of the crankcase 7Place the bearing housing into the holding fixture; then apply blue Loctite