2006 Arctic Cat ATVs factory service and repair manual, Page 350Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 350

15Secure the holding fixture (A) in vise; then install the driven bevel gear (C), cam damper (D), spring (E), spring holder
installedAfter seating the circlip, remove the nuts (C), compressor (B), and guide rods (A)Apply grease to the O-ring seal
on the housing 1NOTE: If any of the output bevel gear (backlashrelated) parts have been replaced, the Adjusting Backlash
and Adjusting Tooth Contact procedures must be followed 17Install the driven gear assembly (B) in the crankcase; then tighten