2006 Arctic Cat ATVs factory service and repair manual, Page 355Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 355

2Install the two bevel washers (A) with the concave side directed towards the driven pulley; then use the pulley holder (B)
recess from the plate surface to the clutch collar 4Check that drive belt deflection is within specifications (see Section
2)5Remove the clutch holding tool (A); then install the three cap screws and tighten the drive clutch cover to specifications
using crisscross pattern CIf the measurement is less than 14.55 mm (0.573 in, install red drive clutch cover (pln 3201-162)If
the measurement is greater than 15.65 mm (0.616 in, install blue drive clutch cover (pln 3201-163)If the length cannot be