2006 Arctic Cat ATVs factory service and repair manual, Page 358Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 358

Installing Top-Side Components APiston BCylinder CCylinder Heads DCamshafts I NOTE: If the piston rings were removed, install
sure the expander ends do not overlapStagger the end gaps of the upper and lower thin oil rings according to the illustration
I Compression Ring End Gap S3 Thin #3 Thin Oil Ring Oil Ring End Gap End Gap I NOTE: When installing the circlips in the
piston, compress them only enough to installDo not over compress 2Install two alignment pins (A) for each cylinder; then
position new base gasket (B) as shown#2 Compression Ring End Gap Oil Ring Expander End Gao BInstall compression ring #2 (C)