2006 Arctic Cat ATVs factory service and repair manual, Page 360Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 360

10Apply clean engine oil to the camshaft; then apply thin coat of Three Bond Sealant (pln 0636-070) (A) to the outer surface
washers, 0.9 kg-m (6.5 ft-lb); and 6, 1.0 kg-m (6.5 ft-lb); (A) 1.0 kg-m (7.0 ft-lb)Use the illustrated tightening sequence
for cap screws 1-614Repeat steps 8-12 for the front camshaftIAll views are from the right side for the front camshaft 15Install
pin (A), spring (B), washer (C), and chain tensioner cap bolt (D); then tighten cap bolt to specifications 12Adjust valve
clearance (See Section 2); then apply grease to O-rings (A) and install the tappet coversTighten the cap screws (B) to specifications