2006 Arctic Cat ATVs factory service and repair manual, Page 363Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 363

13Connect the four disconnect plugs as shown; then connect the battery positive cable and starter lead to the starter relay
and oil pressure warning lead; then connect the drive belt failure detector lead and the engine brake control servo lead
to the main harnessConnect the spark plug wires12Install the electronics mounting tray with the CDIstarter relay, and EBC
mozule -attached; then secure with-four mounting screws 17Remove the tape from the carburetor inlets checking for any foreign
material; then using red Loctite #271, install the lower air cleaner housing and tighten the mounting screws securely18Install