2006 Arctic Cat ATVs factory service and repair manual, Page 370Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 370

10Unscrew and remove the idle speed adjuster assemblyAccount for the spring and washerASSEMBLING Install the slow jetTighten
positioned 2Install the pilot screw, spring, washer, and 1 NOTE: Turn the pilot screw clockwise until it is lightly seated;
then turn it counterclockwise the recommended number of turns as an initial setting1 NOTE: Note the locations of the jets
and holder during assembling procedures 1 NOTE: Check float arm height by placing the carburetor on its side wlfloat contacting
the needle; then measure with caliper the height when the float arm is in contact with the needle valveFloat arm height should