2006 Arctic Cat ATVs factory service and repair manual, Page 374Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 374

8Loosen the outer jam nut securing the throttle cable to the carburetor body; then route the cable out of the way 11Use tape
screws securing the float chamber and remove the float chamberAccount for four screws and one O-ring gasket Whenever any
maintenance or inspection is made on the fuel system during which there may be fuel leakage, there should be no welding,
smoking, open flames, etc in the area 10Disconnect the coolant hoses, breather tubes, and intake tubes; then remove the carburetors
2Remove the set screw (A); then slide the pivot pin (B) out and remove the float (C) Page: 374 Arctic Cat ATV 2006 -All Models