2006 Arctic Cat ATVs factory service and repair manual, Page 375Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 375

1Remove the vacuum chamber cover (A), spring (B), and vacuum piston (C); then remove the jet needle (D) and spring seat (E)
rod (D)The float valve spring (E) must not be compressedFloat height should be mm (0.16 in1 NOTE: Do not remove the pilot
screws unless idle problems have been encounteredIf pilot screws are removed, the carburetors will have to be synchronized
after installation (see Troubleshooting sub-section in this section) 3Remove set screw (A); then remove the float pivot pin
(B), float (C), needle valve, slow jet (D), and main jet (E) 1 NOTE: Increasing the float height lowers the fuel level, and