2006 Arctic Cat ATVs factory service and repair manual, Page 376Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 376

4Remove the screws (A) and pump cover (B) from the carburetor body; then remove the diaphragm (C) and O-ring (D) 2Install
hook the needle hanger (A) onto the float tab; then insert the float pivot pin (B) into the pivot post and tighten the set
screw (C) 5Install the piston into the carburetor body and engage the tab (A) of the diaphragm into the recess (B); then
install the spring and vacuum chamber coverSecure with four screws 6Install the pump diaphragm and O-ring; then install the
pump cover and secure with two screws1 NOTE: Checkladjust float height (see Adjusting Float Height sub-section in this section)Float