2006 Arctic Cat ATVs factory service and repair manual, Page 377Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 377

7Place the float chamber into position making sure the O-ring is properly positioned; then secure with Phillips-head screws
with the screwsConnect the gas hose to the fuel pump; then connect the carburetor float chamber drains and route outlet hose
behind engineInstall the air filter housing onto the carburetors and secure with eight cap screws; then install the air filter,
filter housing cover, and storage compartment coverPour the appropriate amount of coolant into the cooling system; then check
for leaksCheck for proper throttle cable and choke cable free-playAdjust as necessaryTurn the ignition switch to the ON position;
then check the gas hose connections, float chamber seals, and chamber vents for leaks Place all metallic components in wire
basket and submerge in carburetor cleanerSoak for 30 minutes; then rinse with fresh parts-cleaning solventWash all non-metallic
components with soap and waterRinse thoroughlyDry all components with compressed air only making sure all holes, orifices,