2006 Arctic Cat ATVs factory service and repair manual, Page 380Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 380

INSTALLING REMOVING 1Place the gas tank into position on the frame; then install the two cap screwsTighten securely2Connect
or leaks3Inspect tank cap and tank for leaks, holes, and damaged threadsINSTALLING 1Place the gas tank into position in the
frame; then install the cap screwsTighten securely2Connect the gas hose(s) from the carburetor(s); then connect the fuel
gauge connector 3Install the vent hose; then fill the gas tank with gasoline4Turn the ignition switch to the ON position
(650 V-Twin) or start the engine (on other models) and inspect for leakageCEY 1234Gas Tank Tank Cap Gasket Sender 5Seal 6Filter
7Mounting Plate 8Screw 9Hose Clamp 10Hose 11Fuel Pump 12Machine Screw 13Lock Nut 14Hose Clamp 151617181920 Fitting Grommet
Shield Shield Shield Cap Screw 5Install the rear fenders and rack (see Section 8); then install the seat making sure it latches
securely Gas Tank Valve Whenever any maintenance or inspection is made on the fuel system during which there may be fuel