2006 Arctic Cat ATVs factory service and repair manual, Page 381Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 381

INSTALLING 1Place the valve and gasket into position on the tank and secure with the nutsTighten to specifications2Install
not bend or obstruct the routing of the carburetor vent hoseMake certain that the vent hose is securely connected to the
carburetor and the opposite end is always open Electric Fuel Pumo The electric fuel pump and fuel level sensor are non-serviceable
assemblyIf either fails, the fuel pump assembly must be replacedi NOTE: For testing the fuel pump, see Testing Electric Fuel
Pump in this section Drain the gas tank prior to this procedure Remove the gas hose from the valve by releasing the spring
clampRemove the two nuts securing the valve; then remove the valveAccount for the gasketInspect the gasket and valveltank
mating surfaces for damage or deteriorationInspect for and remove any obstructions in the valve Vacuum Pulse Fuel Pump (400