2006 Arctic Cat ATVs factory service and repair manual, Page 390Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 390

Fan REMOVING 3Remove the impeller cap screw, washer, and gasket4Remove the mechanical seal using this procedure 1Remove the
REMOVINGIDISASSEMBLING 15 ICase 2Cap Screw 3Gasket 40-Ring 5Impeller 6Mechanical Seal 7Seal 8Cap Screw 9Washer 10Washer 11Cap
Screw 12Cap Screw 13Shaft w1Bearing 14Joint 15Pin H NOTE: Treat seals and O-rings with clean antifreeze for initial lubrication
1Press the mechanical seal with pump drive seal into the impeller by hand 2Install the mechanical seal assembly onto the
water pump shaft and secure with the cap screw, washer, and gasketTighten the cap screw securely3Place the water pump case
into position and secure with the three cap screwsNote the position of the long cap screw from removal 4Fill the cooling
system with the recommended amount of antifreezeH NOTE: While the cooling system is being filled, air pockets may develop;
therefore, run the engine for five minutes after the initial fill, shut the engine off, and then fill the cooling system
1Drain the coolant2Remove the three cap screws securing the water pump caseNote the position of the long cap screw and account