2006 Arctic Cat ATVs factory service and repair manual, Page 392Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 392

3Using Seal Removal Tool (pln 0644-0721, remove the mechanical seal and the oil seal from the bearing housing CC784 6Using
the seal down until it is fdly seated DISASSEMBLING 1Finish removing the two Phillips-head cap screws securing the cover
to the bearing housing; then remove the coverAccount for the O-ring2Remove the E-ring securing the impellerlshaft to the
bearing housing; then remove the impellerlshaft 2Place the new mechanical seal into the bearing housing; then tap it down
until it is fully seatedW NOTE: large deep-well socket can be used to drive the seal down evenly 3Install the impellerlshaft
assembly into the bearing housing; then secure with the E-ringW NOTE: Make sure the E-ring is fully seated and the impeller