2006 Arctic Cat ATVs factory service and repair manual, Page 393Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 393

4While holding the bearing housing assembly in position on the engine, slowly rotate the impeller until the impellerlshaft
cap screwsTighten the four tom-head cap screws securely; then tighten the remaining cap screws to specificationsFill the
engineltransmission with the proper amount of recommended oilFill the cooling system with the proper amount of recommended
coolantH NOTE: While the cooling system is being filled, air pockets may develop; therefore, run the engine for five minutes
after the initial fill, shut the engine off, and then fill the cooling system 7Check the entire cooling system for leakage
CAUTION After operating the ATV for the initial 5-10 minutes, stop jhe engine, allow the engine to cool downand check the
coolant levelAdd coolant as necessary Water Pump Alternator Cover (650 V-Twin) H NOTE: Check for water pump seal leakage
by examining drain catch tank (A) 2Connect the two coolant hoses to the water pump and secure with the clamps3From inside