2006 Arctic Cat ATVs factory service and repair manual, Page 395Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 395

11Install the recoil starter (see Installing Left-Side Components Section 3)12Install the coolant hoses onto the pump cover;
1Turn the ignition switch ON and listen for momentary "whirring" sound of the pump building pressureIf the sound is heard
(10 seconds), no electrical checks are necessaryTurn the ignition switch OFF2Disconnect the fuel hose from the pump to the
gas tank valve; then install suitable pressure gauge 9Install the alternator cover (see Installing Left-Side Components in
Section 3); then install the impeller and tighten clockwise to specifications 3Turn the ignition switch to the ON positionThe
fuel pressure should build until the pump shuts offPressure should read 0.18-0.23 kg-cm2 (2.6-3.3 psi)4If the pump is not
running, disconnect the fuel pumpltank sensor connector by reaching under the rear rack from behind 10Make sure that the
alignment pins are correctly inserted; then using new gasket, install the water pump cover and tighten the cap screws to