2006 Arctic Cat ATVs factory service and repair manual, Page 396Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 396

5Connect multimeter to the power supply leads with the red tester lead to the brown wire and the black tester lead to the
gas tank Take care not to damage the float or float arm or replacement of the entire assembly will be 2Remove the spring
clamp; then remove the fuel hose 3Remove the screws securing the fuel pump to the gas tank; then make reference mark on the
fuel pump and tank 6Using duct tape or other suitable means, cover the fuel pump opening INSPECTING W AT THIS POINT If the
pump has failed earlier test and must be replaced, proceed to INSTALLING 1Inspect the fuel screen and blow clean with low
pressure compressed air 4Rotate the fuel pump assembly clockwise 90' to allow removal without removing the fuel tank 2Move
the float lever and check for free movementThe float assembly should return to the lower position without forceIf not, replace