2006 Arctic Cat ATVs factory service and repair manual, Page 397Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 397

3Test the fuel gauge tank sensor by connecting multimeter (A) to the fuel sensor leads (B); then select OHMSThe multimeter
fenders, rack7 and seat making sure the seat locks securely Testing Vacuum Pulse Fuel Pump (400 FIS15001650 ) NOTE: If readings
are erratic, clean the resistor wiper and resistor with clean alcohol and retestIf still not correct, replace the fuel pump
assemblyW W AT THIS POINT Prior to removing the vacuum pulse fuel pump, the following check should be performed to determine
that removal is necessarv INSTALLING 1Mark the new fuel pump with reference mark in the same location as the removed pump;
then place the new gasket on the pump2Remove the material covering the fuel pump opening; then carefully guide the fuel pump
into position taking care not to damage the float or float lever Whenever any maintenance or inspection is made on the fuel
system during which there may be fuel leakage, there should be no welding, smoking, open flames, etc in the area 1Disconnect