2006 Arctic Cat ATVs factory service and repair manual, Page 402Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 402

VOLTAGE (Wiring Harness Side) 3When the brake pedal is depressed, the meter must show less than ohmIf the meter shows more
tester lead to the orange wire; then connect the black tester lead to ground RESISTANCE (Switch Connector) Always disconnect
the battery when performing resistance tests to avoid damaging the multimeter 3The meter must show battery voltage1 NOTE:
If the meter shows no battery voltage, troubleshoot the battery, fuse, switch, or the main wiring harness1 NOTE: If the meter
shows battery voltage, the main wiring harness is good; proceed to test the switchcomponent, the connector, and the switch
wiring harness for resistance 1Set the meter selector to the OHMS position 2Connect the red tester lead to one black wire;
then connect the black tester lead to the other black wire RESISTANCE (Switch Connector) A CAUTION Always disconnect the
battery when performing resistance tests to avoid damaging the multimeter 1 NOTE: The brake lever must be compressed for