2006 Arctic Cat ATVs factory service and repair manual, Page 404Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 404

On the coolant temperature switch when the water temperature reaches 112-118' (234-244' F), the meter should read closed
3The meter must show less than ohm Fan Motor The connector is located behind the fan assembly1 NOTE: The ignition switch
must be in the ON 1 NOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the
connector, or the switch wiring harness1 NOTE: To determine if the fan motor is good, connect the blue wire from the fan
connector to 12 volt DC power supply; then connect the black wire from the fan connector to groundThe fan should operate
position VOLTAGE (Main Harness Connector to Fan Motor) 1Set the meter selector to the DC Voltage position2Connect the red
tester lead to the blacklred wire (the black 2-prong at the fan motor); then connect the black tester lead to ground3The
meter must show battery voltage 1 NOTE: If the meter shows no battery voltage, troubleshoot the battery, fuse, motor, or
the main wiring harness A CAUTION Care should be taken to keep clear of the fan blades 1 NOTE: If the meter shows battery