2006 Arctic Cat ATVs factory service and repair manual, Page 406Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 406

Iresistance tests to avoid damaging the multimeter 1 1Set the meter selector to the OHMS position Iways disconnect the battery
The ianition coil is on the left-side frame above the engineTo access the coil, the left-side panel (see Section 2) must
be removedRESISTANCE Always disconnect the battery when performing resistance tests to avoid damaging the multimeter1 NOTE:
For these tests, the meter selector should be set to the OHMS position and the primary wire(s) should be disconnected Primary