2006 Arctic Cat ATVs factory service and repair manual, Page 408Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 408

OIL TEMPERATURE LIGHT VOLTAGE (400) 1 NOTE: The ignition switch must be in the ON position, and the test must be performed
does not include the 400 TBX or the 400 VP modelsi NOTE: Prior to testing the speed sensor, inspect the three-wire connector
on the sensor harness (400 FISl500 models) or on the speed senual sor (500 auto1650 HI1650 V-Twin models) for contamination,
broken pins, andlor corrosion 1Connect the jumper positive wire to the power source terminal on the indicator light connector2Connect
the jumper ground wire to the neutral terminal on the indicator light connector3The neutral position indicator light should
illuminateREVERSE POSITION LIGHT 1Connect the jumper positive wire to the power source terminal on the indicator light connector2Connect
the jumper ground wire to the reverse terminal on the indicator light connector3The reverse position indicator light should
illuminatei NOTE: If light fails to illuminate in any one of the indicator light tests, the connector, wiring harness, or