2006 Arctic Cat ATVs factory service and repair manual, Page 409Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 409

2Remove the sensor from the sensor housing accounting for an O-ring 3Install the new speed sensor into the housing with new
backward; the meter must show and DC volts alternately (5001650 HI) or and 12 DC volts alternately (4001500 manual1650 V-Twin)1
NOTE: If the sensor tests are within specifica- Ignition Switch On the 4001500, the connector is the black three-wire one
beneath the steering post coverOn the 650 Hll650 V-Twin, the connector is four-wire oneTo access the connector, the cover
must be removedVOLTAGE 1NOTE: Perform this test on the lower side of the connector tions, the speedometer must be replacedSee
Section 9 To replace speed sensor, use the following procedureDisconnect the three-wire connector from the speed sensor harness
or from the speed sensor; then remove the Allen-head cap screw securing the sensor to the sensor housing 1Set the meter selector