2006 Arctic Cat ATVs factory service and repair manual, Page 410Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 410

1 NOTE: If the meter shows no battery voltage, troubleshoot the battery or the main wiring harness RESISTANCE Handlebar Control
wire; then connect the black tester lead to the gray wire3With the dimmer switch in the HI position, the meter must show
less than ohm1 NOTE: If the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the connector,
or the switch wiring harness 4The meter must show less than ohm5Turn the ignition switch to the LIGHTS position6Connect the
red tester lead to the red wire; then connect the black tester lead to the orange wire (STD) or to the rediblack wire (650
Hll650 V-Twin)7The meter must show less than ohm8Connect the red tester lead to the red wire; then connect the black tester
lead to the gray wire RESISTANCE (LO Beam) 9The meter must show less than ohm10With the switch in the OFF position, connect
the red tester lead to the red wire and the black tester lead to each of the remaining wiresThe meter must show an open circuit