2006 Arctic Cat ATVs factory service and repair manual, Page 411Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 411

With the starter button depressed, the meter must show 0.50.7 DC voltsWith the starter button released, the meter must show
wire3With the switch in the OFF position, the meter RESISTANCE A CAUTION 1Set the meter selector to the OHMS position Iresistance
tests to avoid damaging the multimeterI Always disconnect the battery when performing must show an open circuit 4With the
switch in the RUN position, the meter must show less than ohm1 NOTE: If the meter shows more than ohm of resistance, troubleshoot
or replace the switchcomponent, the connector, or the switch wiring harness 2Connect the red tester lead to the red wire;
then connect the black tester lead to the white wire3With the selector switch in the 2WD position, the meter must show closed
circuit RESISTANCE (Reverse Override) 4With the selector switch in the 4WD position, the meter must show an open circuit1
NOTE: If the meter does not show as specified, replace the front drive selector switch The connector is the four-prong white