2006 Arctic Cat ATVs factory service and repair manual, Page 413Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 413

3With the engine running at the specified RPM, all wire tests must show 60 A.Cvoltsrn Do not run the engine at high RPM for
batthe Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 3With the engine running
at constant 5000 RPM (with the headlights on), the meter must show 14-15.5 DC volts 2Connect the red tester lead to the green
wire; then connect the black tester lead to the blue wireThe meter reading must be within specificationRESISTANCE (Source
Coil) CAUTION Do not run the engine at high RPM for more than 10 secondstor coilno load1 NOTE: If voltage is lower than specified,
test sta- 1Set the meter selector to the OHMS position2Connect the red tester lead to the yellow wire; then connect the black
tester lead to the white wire3The meter reading must be within specification1 NOTE: If the meter shows other than specified
in any resistance test, replace the stator assembly VOLTAGE (Stator Coil The connector is the black and white one on the