2006 Arctic Cat ATVs factory service and repair manual, Page 414Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 414

i NOTE: The battery must be at full charge for these tests 3Crank the engine over using the electric starter 4The meter reading
at high RPM for more than 10 seconds1 NOTE: If voltage is lower than specified, test stator coilno load 4The meter reading
must be within specificationPEAK VOLTAGE (5001650 ) 1 NOTE: All of the peak voltage tests should be made using the Fluke
Model 73 Multimeter (pin 0644-191) with Peak Voltage Reading Adapter (pin 0644-307)If any other type of tester is used, readings
may vary due to internal circuitry1 NOTE: The battery must be at full charge for VOLTAGE (Stator Coil The connector is the
white one on the right side behind the enginei NOTE: Test the connector that comes from the engine these tests Magneto Coil
(Trigger) 1Set the meter selector to the DC Voltage position 1Set the meter selector to the A.CVoltage position2Test between
the three black wires for total of three tests 2Connect the red tester lead to the green wire; then connect the black tester