2006 Arctic Cat ATVs factory service and repair manual, Page 420Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 420

NOTE: If the meter showed battery voltage but the starter did not operate or operated slowly, inspect battery voltage (at
slide the boot awayNOTE: The ignition switch must be in the ON position, the emergency stop switch in the RUN position, the
reverse lever (on manual transmission models) in the FORWARD position, and the shift lever (on automatic transmission models)
in the NEUTRAL position 1Set the meter selector to the DC Voltage position2Connect the red tester lead to the starter terminal;
then connect the black tester lead to ground3With the starter button depressed, the meter must show battery voltage and the
starter motor should operateW NOTE: Make sure that the ignition switch is in the ON position, transmission in neutral, brake
lock released, and the emergency stop switch in the RUN position 3Depress the starter button while observing the multimeterThe
multimeter should drop to volts and "click" should be heard from the relayNOTE: If "click" is heard and any voltage is indicated