2006 Arctic Cat ATVs factory service and repair manual, Page 423Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 423

2With the Arctic Cat Engine Tachometer (pln 0644-275) connected, start the engine and run at the specified RPM3Ignition timing
or shield the ATV around the inspection plugAlways wear protective glasses when doing timing checks 1Attach the engine Timing
Light (pln 0644-197) to the front spark plug high tension lead; then remove the timing inspection plug from the left-side
crankcase cover2With the Arctic Cat Engine Tachometer (pln 0644-275) connected, start the engine and run at the specified
RPM3Ignition timing should be according to the following chart and illustrationEngine Speed Slot (B) Aligned With Advanced
mark (C) on alternator rotor (5' BTDC) Advanced mark (D) on alternator rotor (28' BTDC) O0 and below 5000 and above 2Install
the Reset Connector (pln 0486-161) into the forward 4-pin connector; then turn the ignition switch to ONAllow the speedometerltachometer
to power-up and reset to the running mode; then turn the ignition switch to OFF3Remove the reset connector and connect the