2006 Arctic Cat ATVs factory service and repair manual, Page 427Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 427

Tilt Sensor Voltage (650 V-Twin) 1loss of vehicle conirol r=sulting in injury or death1 A CAUTION Do not drop the tilt sensor
remove the right-side mounting screw securing the sensor to the rear frame 2Turn the ignition switch to the ON positionThe
multimeter should read battery voltageIf battery voltage is not indicated, check the 30-amp fuse?wiring harness? or the ignition
switch 2Install the needle adapters to the multimeter leads; then select DC Voltage on the multimeter 3Remove the red tester
lead and connect to the blueibrown wire (B)The multimeter should read 5.0 DC voltsIf the specified voltage is not indicated,
check wire connections at the CDI or substitute another CDI to veri the test 3Connect the red tester lead to the blueibrown