2006 Arctic Cat ATVs factory service and repair manual, Page 430Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 430

SPECIAL TOOLS Drive System NOTE: Some photographs and illustrations used in this section are used for clarity purposes only
screws carefully into the housing; then use the following torque values1 M6 (TOM T-30 Recess) M8 (TOM T-40 Recess) MI0 (TOM
T-50 Recess) If noise is heard from the gear case area, it can be difficult to locate andlor diagnoseIf the noise is related
to wheel speed, but not to engine RPM, the problem is probably in the final drive or engineltransmission bevel gear setWhen
problem is localized, number of inspections must be made to pinpoint that problemThe most obvious of the inspections include
CV boots, wheel and hub nut tightness?wheel bearing damage, gear case lubricant contamination7low lubricant level, seal leakage,
CV joints? or selector armNOTE: Small metallic particles will collect on the magnetic drain plug as normal part of break-in
and will also give metallic cast to drained lubricantContamination would include large particles or water which gives "milky"