2006 Arctic Cat ATVs factory service and repair manual, Page 431Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 431

(400 FIS500650 HI7650 V-Twin) 1 NOTE: The actuator is not serviceable componentIf it is defective, it must be replaced Front
grinding sounds, the actuator must be replacedREMOVING INSTALLING 1Remove the left-front inner fender panel; then disconnect
the connector on the actuator harness2Using T-30 torx wrench, remove the mounting cap screw from the driveshaft side of the
actuator 1Lubricate the O-ring on the actuator; then ensure that all mounting surfaces are clean and free of debris2Alim
the actuator with the selector shaft and slide it forward onto the shaft taking care to engage the cap screw in the slot
of the front mounting tab 3Remove the mounting cap screw from below the actuator on the suspension side 3While holding the