2006 Arctic Cat ATVs factory service and repair manual, Page 432Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 432

REMOVING DIFFERENTIAL 1Secure the ATV on support stand to elevate the wheels Make sure the ATV is solidly supported on the
the hex nut and washer 5Tighten the remaining cap screws; then connect the electrical plug to the main harness 6Turn the
ignition switch to the ON position and check the operation by shifting the selector switch several times7Secure the wiring
harness to the frame with nylon cable tie; then install the inner fender panel Front Differential (FIS Models) i NOTE: To
remove the rear gear case on FIS models, see Rear Gear Case (FIS Models) in this section 6Release the brake lever locki NOTE:
It is not necessary to remove the brake hoses from the calipers for this procedure 7Remove the two brake calipersAccount