2006 Arctic Cat ATVs factory service and repair manual, Page 437Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 437

4On the 400 FISl5001650 HI, install shaft into the housing; then install and secure with Boot Clamp (pln 0423-393) and the
splines with parts-cleaning solvent and dry with compressed air; then lubricate with recommended grease 5On the 400 FISl5001650
HI, place the pinion housing with new gasket onto the gear case housing; then secure with the existing cap screwsTighten
to specifications1NOTE: If new gear case housing is being installed, tighten the cap screws to 3.5-4.3 kg-m (25-31 ft-lb)