2006 Arctic Cat ATVs factory service and repair manual, Page 440Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 440

7Using the 48 mm Internal Hex Socket (pln 0444-104), remove the lock collar securing the pinion gear assembly1 NOTE: On front
(pin 0444-127) and hammer, remove the pinion gear from the gear case housing 1 NOTE: If gears are being replaced, use the
existing shimsThe numbers are scribed onto the gears: the ring gear has the number on the opposite side of the gears, and
the pinion gear has the number on the end of the pinion gear shaft by the splinesIf no number is present, it should be considered