2006 Arctic Cat ATVs factory service and repair manual, Page 444Get this manual

2006 Arctic Cat ATVs factory service and repair manual, Page 444

2Using propane torch, heat the area surrounding the needle bearing to soften the Loctite 11Making sure the O-ring is properly
Removing Needle Bearing 1 NOTE: Removing the needle bearing is rarely necessaryAvoid removing the needle bearing unless the
bearing is clearly damaged 1NOTE: This procedure can be performed on rear gear case Place 6.35 mm (114 in drill bit on the
inside surface of the needle bearing (against the bottom side); then drill through the pinion shaft needle bearing housing
Installing Needle Bearing red Loctite to the outside of new bearing; then place the new bearing into the housing Page: 444